3 Circuits Rotating Wind Turbine Slip Ring Electrical Data Carbon
Brush ,Contact 1000V AC/DC
LPW-02 Wind Turbine Slip Ring This unit can be used in any
electromechanical system that requires unrestrained, continuous
rotation while transferring power or data from a stationary to a
This is constantly being extended in order to meet the developments
in signal and data Transmission.
Slip rings are used in wind mills in wind turbine generators and
for pitch control.
JINPAT has developed a com-prehensile standard programmed that is
able to offer optimum solutions.
The standard programmed enables the creation of slip ring bodies of
any number of poles up to 100 for power and data signal currents.
Slip ring bodies can be supplied either as open slip ring bodies to
be built per customers requirements or in a housing of
impact-resistant plastic or sheet metal.The voltage rating can
approach to 1000VAC/DC or higher.
|Working Temperature||-35℃~ +50℃|
|Working Humidity||60%RH or higher|
|Voltage Rating||1000VAC/DC or higher|
|Current Rating||30A per circuit|
|Dielectric Strength||≥500V@50Hz between each circuit|
|Insulation Resistance||1000MΩ@ 500VDC|
|Electrical Noise||1mΩ Min|
|Contact Material||Carbon Brush|
|Lead Wire Size||High Temperature Resistant Material|
|Lead Wire Length||Standard 250mm(9.843inch)|
|IP43 or higher|
Wind turbine generator
1. 3 circuits models
2. Electrical data
3. Compatible with data bus protocols
4. Sealed units are also available
5. Control and data transmission
6. Wiring and max. number of poles
7. More technical details
8 Volume of delivery
9. Flexible, color-coded, silver-plated, insulated lead wires
1. Digital signals up to max. 500 kB
2. Amperages up to 1200 A and volt- age up to 24 kV
3. Diameters > 10 m high rotation speed
4. Extreme operating conditions
5. Protection class: IP 43
If you want to know more details about JINPAT Slip Rings, please
contact us with your special needs!